Blog Post-4 WATER JET PREP

 Water Jet prep


Making the Prototype helped to figure out that my measurements were not accurate when it was about time to do the laser cut. In the studio, the professor helped me to adjust and print.

When the first one was printed, it was too large for the requirements of 6x6 in copper plate; a second print was more accurate to the first idea that i had. Later in Rhino i scaled down a bit more so it will fit in the copper plate without any issues when it's time to print in the water jet.

Laser Cut Prototype





Rhino Adjusted Stair Copper mini Sculpture 








Comments

Post a Comment

Popular posts from this blog

Rhino Castle 1

Image
Inspiration  I found some inspiration in medieval castle do develop this project (specifically in the tall towers and cone shaped roofs) I also added a little bit of my personal touch that came from nostalgia challenges This is my first time using Rhino, and it was a big challenge for me to remember all the commands, and information reviewed in class. I reviewed the class notes, and I did some research in order to build basic geometrical shapes.
Read more